Waste Reducers

Waste Reducers

Our waste pipe and fittings are compatible with most push fit systems such as Hunter, Polypipe and Bartol (will not fit solvent weld pipework).


The size of pushfit pipe and fittings can be described two different ways. Traditionally it was sized based on the internal bore of the pipe, though this is changing and now it's becoming common to describe it by the pipe's outside diameter.


Old way to describe size (based on pipe nominal bore) New way to describe the same size (based on pipe outside diameter) Typical use
1¼″ / 32mm 34mm Bathroom wash hand basins
1½″ / 40mm 41mm Kitchen sinks, baths and showers
2″ / 50mm 54mm Industrial / commercial

 

  • 1-1/2 Inch x 1-1/4 Inch Push-fit Fitting Reducer

    1-1/2 x 1-1/4 inch pushfit fitting reducer, available in white, black or grey. Pushes into a 1-1/2 inch fitting to let it accept 1-1/14 inch pipe. Our waste pipe and fittings are compatible with most push fit systems such as Hunter, Polypipe and Bartol (will not fit solvent weld pipework)…

    £1.27

    £1.27

    Info
  • 1-1/2 Inch x 3/4 Inch Push-fit Fitting Reducer

    1-1/2 inch x 3/4 inch push-fit fitting reducer. Colour may vary. Pushes into a 1-1/2 inch pushfit waste fitting to allow it to accept 3/4 inch pipe Our waste pipe and fittings are compatible with most push fit systems such as Hunter, Polypipe and Bartol (will not fit solvent weld pipe…

    £1.94

  • 1-1/4 Inch x 3/4 Inch Push-fit Fitting Reducer

    1-1/4 inch x 3/4 inch pushfit fitting reducer. Colour may vary. Pushes into a 1 1/14 inch pushfit waste fitting to allow it to accept 3/4 inch pipe. Our waste pipe and fittings are compatible with most push fit systems such as Hunter, Polypipe and Bartol (will not fit solvent weld pip…

    £1.36

  • 110mm x 1-1/4 Inch Or 1-1/2 Inch Rubber Reducer

    The DS25 will accept two waste pipes of either 32mm to 40mm diameter. It is made from flexible EPDM and manufactured with one inlet open and one closed (the closed inlet can be opened with a sharp knife). The DS25 can be fitted into a drain socket by replacing the existing ring seal, or inside…

    £6.09

  • 2 Inch x 1-1/2 Inch Push-fit Fitting Reducer

    2 inch x 1-1/2 inch pushfit fitting reducer, pushes into a 2 inch fitting to let it accept 1.5 inch pipe. Our waste pipe and fittings are compatible with most push fit systems such as Hunter, Polypipe and Bartol (will not fit solvent weld pipework). The size of pushfit pipe and fittings c…

    £2.74

  • 2 Inch x 1-1/4 Inch Push-fit Fitting Reducer

    2 inch x 1-1/4 inch push-fit fitting reducer, pushes into a 2 inch fitting to let it accept 1-1/4 inch pipe. Our waste pipe and fittings are compatible with most push fit systems such as Hunter, Polypipe and Bartol (will not fit solvent weld pipework). The size of pushfit pipe and fitting…

    £2.74

    £2.74

    Info
209
Loading
Top